Inside an Extinguisher

In the last section, we saw that there are three essential elements involved in producing fire -- heat, oxygen and fuel. To put a fire out, you need to effectively remove one of these elements.

• The best way to remove heat is to dump water on the fire. This cools the fuel to below the ignition point, interrupting the combustion cycle.
• To remove oxygen, you can smother the fire so it is not exposed to air. One way to smother a small fire is to cover it with a heavy blanket. Another way is to dump nonflammable material, such as sand or baking soda on top of it.
• Removing the fuel is the most difficult approach for most fires. In a house fire, for example, the house itself is potential fuel. The fuel will only be removed once the fire has burned all of it up.

Fire extinguishers are sturdy metal cylinders filled with water or a smothering material. When you depress a lever at the top of the cylinder, the material is expelled by high pressure, similar to the way material is forced out of an aerosol can. The diagram below shows a typical design.

In this extinguisher, a plastic siphon tube leads from the bottom of the fire-suppressant reservoir to the top of the extinguisher. A spring-mounted valve blocks the passageway from the siphon to the nozzle. At the top of the cylinder, there is a smaller cylinder filled with a compressed gas -- liquid carbon dioxide, for example. A release valve keeps the compressed gas from escaping.

Most dry-chemical fire extinguishers have a built-in pressure gauge. If the gauge indicator is pointing to "recharge," the pressure in the extinguisher may be too low to expel the contents. The National Fire Protection Association recommends having dry extinguishers inspected every six years, even if the gauge indicates correct pressure.

To use the extinguisher, you pull out the safety pin and depress the operating lever. The lever pushes on an actuating rod, which presses the spring-mounted valve down to open up the passage to the nozzle. The bottom of the actuating rod has a sharp point, which pierces the gas cylinder release valve.

The metal safety pin prevents the operating lever from closing accidentally.

The operating lever pushes down on an actuating rod (the blue piece).

The compressed gas escapes, applying downward pressure on the fire-suppressant material. This drives the material up the siphon and out the nozzle with considerable force. The proper way to use the extinguisher is to aim it directly at the fuel, rather than the flames themselves, and move the stream with a sweeping motion.
In the next section, we'll look at the major types of extinguishers.

http://home.howstuffworks.com/fire-extinguisher1.htm